FAQs: STYLPRO Anti-Fog Mirror

Yes, it is easy to install your STYLPRO Clear View Mirror to your surface. Place the wall suction mount on to a flat smooth surface (try to avoid bumpy rough surfaces), push and twist the wall mouth to the right to secure. Once the wall suction mount is secured to your surface, align the mirror with the wall suction mount and forcefully push the mirror to click into place.

Simply lean the mirror towards you and down to a 90 degree angle from the wall suction mount and the mirror will pop itself out, this is best done in a quick motion. You do not need to remove the wall suction mount from the wall to remove the mirror.

To remove the wall suction mount from the surface, twist the mount to the left until fully released. You may need to pull the small tab to remove the wall suction mount from the surface.

Simply, lift up the flap where the On/Off Button is located to find where to insert the USB-C cable. The wave symbol will light up green while charging. Once your mirror is charged, please ensure to place the silicone power button back into place, ensuring a good seal.

Yes, the STYLPRO Clear View Mirror is specifically designed for use in wet environments. It is equipped with safety features to operate in your bathroom or shower.

You can mount your STYLPRO Clear View Mirror on any smooth surface in your bathroom, whether that is your basin or on your shower wall!

Of course, the STYLPRO Clear View Mirror is safe to use in the shower and will stay fog free! We recommend to not put the mirror into the stream of water.

The STYLPRO Clear View Mirror has a heated electrical pad built into the back of the mirror and ensure the mirror panel stays fog free.

If you get water droplets onto your mirror surface use the handy squeegee to wipe off the excess water.

On the back of your mirror, on the left hand side, is your On/Off button. Simply, long press the On/Off button to switch on the LED light panels, this will also turn on the Anti-Fog Heat Technology.

On the back of your mirror, on the left hand side, is your On/Off button. Simply, long press the On/Off button to switch on Anti-Fog Heat Technology, this will also turn on the LED light panels.

The STYLPRO Clear View Mirror will automatically turn off after 7 minutes to save battery life.

The STYLPRO Clear View Mirror can last up to 20 uses!

It may take up to 4.5 hours to fully charge the battery.

Please find a downloadable version of our instructions here.